Triple dispenser holder - Brushed steel

Our soap dispenser with space for 3 soap dispensers combines functionality and elegance with a stylish design. The soap dispenser holder is part of our exclusive stainless steel bathroom accessories. The holder is in brushed steel. The series comes with a practical strong self-adhesive tape on the back, which means that you can easily mount the product without difficulty and without the need to drill holes in the wall.

It is equipped with a hole with a standard diameter of 28 mm, which means that the holder fits a wide range of soap dispensers.

By mounting the soap dispenser holder on the wall, you make it easier to maintain cleanliness around your sink. The soap dispenser holder can be combined and also used in the shower cubicle or in the kitchen for washing-up liquid.

We recommend the following surfaces:
- Permanently smooth surfaces: Tiles, lacquered surfaces, or veneer sheets.

We do not recommend the following surfaces:
- Wallpaper, wet room wallpaper, uneven/rough surfaces, painted walls, microcement and cement-based surfaces, etc.

We do not recommend placing the products over joints/joints.

In case of uncertainty, you should contact a professional.

Clean the surface thoroughly with a 3M cleaning wipe (not included)

Materials: Stainless steel

Length: 22 cm
Width: 10 cm
Depth: 6.7 cm

Massivt rustfrit stål

Our self-adhesive series allows installation without drilling, which protects your walls. Follow this guide for best results.

1. Choose the Right Surface
To ensure that the products stick well and last a long time, it is important to choose a good surface. We recommend the following surfaces:
- Permanently smooth surfaces: Tiles, lacquered surfaces, or veneer sheets.

We do not recommend the following surfaces:
- Wallpaper, wet room wallpaper, uneven/rough surfaces, painted walls, microcement and cement-based surfaces, etc. as these can affect the adhesiveness and durability of the tape.

2. Prepare the installation site
- Cleaning: Wipe the surface thoroughly to remove dirt and oil with a 3M surface cleaning wipe. If you use your own cleaning agents to clean the wall, avoid cleaning agents that contain oil, as they can reduce the adhesiveness.

3. Assembly
a) Remove the protective film from the tape.
b) Place the product on the surface and press with even pressure for approx. 10 seconds.
c) Wait 24 hours before use so that the glue has time to harden for optimal durability.

Note: We do not recommend placing the products over joints/joints as this may affect the tape.

In case of uncertainty about the suitability of the surface, or if you have special questions about the installation, we recommend contacting a professional.

• Hvis du kan lægge varen i kurven, så er den på lager
• Hvis varen ikke er på lager, kan du skrive dig op
• Fri fragt til pakkeshop ved køb over 599 kr- Ved køb op til 599 kr - 49 kr til pakkeshop & 69 kr til hjemmelevering.
• Køb returlabel online til 49 kr.
• Betal med Visa, Master Card, MobilePay, Apple Pay, Maestro eller Viabill
• Kundeservice info@eleliving.dk - tlf: 89 88 77 90
• Se FAQ for at finde svar på de oftest stillede spørgsmål