Soap dispenser holder

Our soap dispenser holder combines functionality and elegance with a stylish design. The soap dispenser holder is part of our exclusive stainless steel bathroom accessories collection. The holder is in matte black. The series comes with a practical, strong self-adhesive tape on the back, allowing you to easily mount the product without hassle and without the need to drill holes in the wall.

It is equipped with a hole with a standard diameter of 28 mm, meaning the holder fits a wide range of soap dispensers.

By mounting the soap dispenser holder on the wall, you make it easier to maintain cleanliness around your sink. The soap dispenser holder can be combined and also used in the shower cabin or in the kitchen for dish soap.

We recommend the following surfaces:
- Permanently smooth surfaces: Tiles, lacquered surfaces, or veneer panels.

We do not recommend the following surfaces:
- Wallpaper, wet room wallpaper, uneven/rough surfaces, painted walls, microcement and cement-based surfaces, etc.

We do not recommend placing the products over joints/grout lines.

Clean the surface thoroughly with a 3M cleaning wipe (not included)

Materials: Stainless Steel
Load capacity: 2.5 kg

Length: 15.2 cm
Width: 5 cm
Depth: 6.8 cm

Solid stainless steel

Our self-adhesive series allows installation without drilling, which protects your walls. Follow this guide for best results.

1. Choose the Right Surface
To ensure that the products stick well and last a long time, it is important to choose a good surface. We recommend the following surfaces:
- Permanently smooth surfaces: Tiles, lacquered surfaces, or veneer sheets.

We do not recommend the following surfaces:
- Wallpaper, wet room wallpaper, uneven/rough surfaces, painted walls, microcement and cement-based surfaces, etc. as these can affect the adhesiveness and durability of the tape.

2. Prepare the installation site
- Cleaning: Wipe the surface thoroughly to remove dirt and oil with a 3M surface cleaning wipe. If you use your own cleaning agents to clean the wall, avoid cleaning agents that contain oil, as they can reduce the adhesiveness.

3. Assembly
a) Remove the protective film from the tape.
b) Place the product on the surface and press with even pressure for approx. 10 seconds.
c) Wait 24 hours before use so that the glue has time to harden for optimal durability.

Note: We do not recommend placing the products over joints/joints as this may affect the tape.

In case of uncertainty about the suitability of the surface, or if you have special questions about the installation, we recommend contacting a professional.

• Hvis du kan lægge varen i kurven, så er den på lager
• Hvis varen ikke er på lager, kan du skrive dig op
• Fri fragt til pakkeshop ved køb over 799 kr- Ved køb op til 799 kr - 49 kr til pakkeshop & 69 kr til hjemmelevering.
• Køb returlabel online til 49 kr.
• Betal med Visa, Master Card, MobilePay, Apple Pay, Maestro eller Viabill
• Kundeservice: info@eleliving.dk
• Se FAQ for at finde svar på de oftest stillede spørgsmål